Does your Netgear extender face problems staying connected to the main router? Are you not able to get the most out of your WiFi range extender due to this very reason? If that’s the yes that we’ve just sensed, then you must know that your WiFi range extender badly needs a firmware upgrade. Thus, visit mywifiext.local or mywifiext.net depending upon the operating system of the PC you are using, and check if the extender’s firmware update is pending. To know the correct steps, check out the points highlighted below:
- Access the login page of the Netgear WiFi extender using the default web or IP address.
- Complete the login process using a valid username and password.
- Now, move towards the Maintenance section and click Firmware Update.
- See if a firmware update is available for your range extender by selecting Check Now.
- Follow the on-screen instructions.
After your extender gets equipped with the latest firmware version, check whether the problem that we are attempting to address has been resolved or not. If not, then you are advised to take the aid of the troubleshooting techniques highlighted in the next half of the post.
Fixed: Netgear Extender Won’t Stay Connected to Router
- Minimize the Extender-Router Gap
Apart from an outdated version of the extender’s firmware, an excessive distance between the router and the extender plays a prominent role in the emergence of the issue. Therefore, what we suggest you do is make the wireless bridge between both devices small. The lesser the distance between both devices, the lesser the struggle they have to do to communicate. Bringing both devices a little closer will definitely serve the purpose. Once your WiFi devices are brought closer, see to it that the Netgear extender won’t stay connected to router or the problem is fixed. But, bear in mind, not to keep these devices very close.
- Have a Nudge on Ethernet Connection
The Netgear extender and router share a wired connection on very least occasions. However, users are supposed to opt for a wired connection more often. Just in case you have also established the Ethernet connection between both devices and are still facing the same problem, you are required to check the status of the LAN cable. Is it all well? If not, then you’ve just found the reason that might not be allowing a continuous connection between the extender and router. Thus, get the Ethernet cable replaced immediately. Keeping the connection finger-tight is also recommended.
Quick Tip: The presence of devices emanating electromagnetic frequencies around your WiFi extender impacts its performance a lot. So, you need to be very sure that no such device is sharing a room with your Netgear extender.
- Get Rid of Minor Network Glitches
Glitches are unexpected and hence they can affect your internet usage experience at any time. They can also stop you from accessing the Netgear Genie smart setup wizard. This is to inform you that the reason behind these glitches is unknown, it never means that you cannot do away with them. The best-known hack to resolve these glitches is rebooting. Thus, you are suggested to restart your WiFi range extender. You also need to restart your WiFi router for optimal results. But, if you opt to do so, then the router is supposed to be powered down first. After that, switch off the extender and let the devices rest for 20 minutes. Power up all the devices and see if the Netgear extender is still facing problems staying connected to the router.
The Final Thoughts
With that, we are now putting an end to the troubleshooting guide explaining what to do if your Netgear extender won’t stay connected to router. It is anticipated that with the help of the techniques discussed above, you will be able to resolve the problem. You can share your troubleshooting experience in the comment section if it has worked in your favor.